A-type lock puller that can do it all... gas shut-off, nail puller, hammer, pry-bar, wedge tool, venting tool, pull trim, snap padlocks, make examining holes, pull lath plaster, vent windows, and probe during searches. 16" and 12"

This tool meets the specifications of FDNY for their standard officer's tool. It's made of high strength steel with the head welded to the shaft. The shaft is covered with a non-slip gripping surface, the shaft end of the tool is formed into a pry bar capable of slipping into tight spaces. The head of the tool has a flat driving surface, with an A-type lock puller machined into the adz of the blade.
 

The complete "thru-the-lock-kit" available with the tool contains the officer's tool, a double ended "key" tool and shove knife. The kit can be stored inside the non-slip grip of the tool's shaft.

A lock pulling tool, shaped like a "U" with sharp tapered blades that bite into lock cylinders of all shapes and sizes. Extra leverage and original head design provide the mechanical advantage to pull well secured lock cylinders. Opposite chisel end is used to drive rim locks after cylinders are removed. A great officers tool.

Includes two operating key tools, Celtex grips and a prying end.

A tool designed (by a FDNY Fire Lieutenant & licensed locksmith) to pull all types of lock cylinders (rim or mortise) from the various glass type or solid doors.

The K-Tool unit consists of a K-Tool, leather pouch, 2 lock keys and an instructional sheet.

A tool designed to pull all types of lock cylinders too large for the K-Tool unit, such as locks that extend out from the door and 1-inch round are easily pulled with the R-Tool.

The K-Tool unit consists of an R-Tool, carrying bag, set of lock tool keys and a shove knife.